Energenie EG-PMS Manuel d'utilisateur télécharger pdf (Page 14)

EG-PMS-LAN PROGRAMMABLE LAN

SURGE PROTECTOR

All brands and logos are registered trademarks of their respective owners

the excessive load first and then press the Circuit breaker button to

restore the power supply (see Figure #3 above).

To be able to use EG-PMS-LAN you will now have to complete its

LAN configuration.

3.2. Preparing LAN configuration of EG-PMS-LAN

Before configuring EG-PMS-LAN hardware settings, please, let it

obtain its IP address. Follow the steps below:

 Make sure EG-PMS-LAN is connected to the local network with the

provided RJ-45 cable (option A - recommended)

NOTE: by default the factory setting of EG-PMS-LAN is DHCP enabled.

If your LAN has a router with built-in DHCP server (which is very

common) then EG-PMS-LAN will automatically get an IP address from

the DHCP server. Proceed to section 3.3 below in this case.

NOTE: you may prefer to connect EG-PMS-LAN directly to the

managing computer LAN adapter (network card) using the supplied

crossover RJ-45 cable (option B). You might need to use this option if

your LAN does not have DHCP server.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 74 75

Pas de commentaire

Energenie EG-PMS Manuel d'utilisateur Page 14