Energenie EG-PMS Manuel d'utilisateur télécharger pdf (Page 70)

EG-PMS-LAN PROGRAMMABLE LAN

SURGE PROTECTOR

All brands and logos are registered trademarks of their respective owners

9. Troubleshooting

Problem

Solution

The circuit breaker is activated

(tripped).

The load connected to the device is too

high, some of the devices connected to

the EG-PMS-LAN should be disconnected

and the circuit breaker should be reset.

The switching command is not

carried out, the rocker switch

and indicators are not lit.

There is no power supply to the EG-PMS-

LAN. Please, make sure the EG-PMS-

LAN is connected to the power supply and

the rocker switch is switched on.

The status of EG-PMS-LAN in

Power Manager does not

become Connected

Try to ping the device (see section 6.1

above)

EG-PMS-LAN is connected to

local network (ping test is ok)

but not responding.

Reset EG-PMS-LAN by pressing the

Reset button on the side control panel

(see Figure #2 above) or switch it off and

then on again using the Main rocker

switch Z (see Figure #1 above).

Connection to EG-PMS-LAN is

lost. It seems something is

wrong with its IP address.

Make sure EG-PMS-LAN is connected to

LAN and switched on. Launch Find EG-

PMS-LAN utility. You can also try to use

IP config (C) button to let the device renew

its IP address (see section 3.2 above)

1 2 ... 65 66 67 68 69 70 71 72 73 74 75

Pas de commentaire

Energenie EG-PMS Manuel d'utilisateur Page 70